FASTER THROUGHPUT
MARKLESS INDEXING SYSTEM
DEDICATED JOINERY WORKSTATION
EXCHANGEABLE & VARIABLE INDEXING

How fast will my new MEGA-ncw pay for itself?

Look at it this way: Use your new Versidex MEGA just 10hrs/week x 50 weeks/year and you'll have been on it for 500hrs/year. In doing that, you'll biscuit joint your stock about 15 min/ hour faster than your current way, whatever it might be. The MEGA's ease of use and efficiency-based design can save you 125 hours in the above scenario over the course of a year. At a shop rate of $75/hour for labor, that's a SAVINGS of $9375. So payback for your new base-model (Product #3) Versidex is about 4.5 months. But that's a lot of production and maybe your shop isn't quite that busy.

If you'll use your MEGA half as much, say 5 hours/week, a year's SAVINGS is still an impressive $4687., and payback takes about nine months.

So plug in whatever numbers make sense for your shop or factory situation and see what you come up with. Just watch the video and compare the Versidex's speed with how you're doing it now. The Panel Cart would normally be right near the MEGA and we'd probably cycle through panels at a little faster rate than we did in the video while demonstrating how the fixture works, but if you're currently having to manually clamp or use a free hand to hold down your panels while handling your joiner in the other, you are working too hard and too slowly.

Figure out YOUR payback and see how much sense a MEGA makes for your shop. Remember, once you have selected the correct template set from your "library", the MEGA requires no changeout or resetting to mill all three types of butt joints, just the addition of a fence spacer if required by the cabinet design.